EVERY DEVICE CONFIGURED. EVERY SYSTEM INTEGRATED. READY TO COMMISSION.
From protection relay settings and HMI programming to SCADA integration and network configuration, we configure, document, and verify every layer of your electrical control system.
WHAT WE DO
Equipment configuration goes well beyond relay programming. Our team configures the full stack of control system devices — from protection relays and HV breaker logic to SCADA systems, network switches, and time synchronization infrastructure.
We work from our own design packages or integrate cleanly with documentation from another engineering firm. Every deliverable is verified and documented, ready for FAT and site installation.
PROTECTION & CONTROL RELAY CONFIGURATION
Manufacturers supported:
- SEL (Schweitzer Engineering Laboratories)
- GE Grid Solutions
- ABB
- Siemens
- Schneider (MiCOM)
Scope includes:
- Protection & control relay settings calculation and programming
- HV Breaker Control Logic
- IEC 61850 Design & Integration
- Time Synchronization: IRIG-B, PPS, PTP, SNTP
HMI PROGRAMMING
- Interface with Remote HMI
- HMI Screen Development
- Alarms & Indications List
SCADA & RTU CONFIGURATION
- SCADA/RTU Settings
- IO List Preparation
- Data Gateway Configuration
- Protocol Support: IEC 61850 MMS, DNP3, Modbus, SNP, EtherNet/IP
- HMI Programming with Roles & Security (Ignition SCADA, SEL HMI)
- Trending and Historian Setup
NETWORKING
- Network Device Configuration
- Network Redundancy: HSR, PRP
- VLAN Segregation
- Network Switch Settings: Cisco, Ruggedcom, SEL, Hirschmann
FLEXIBLE ENGAGEMENT
Many of our clients engage us for configuration as a standalone service, using documentation from their own design team or another firm. We integrate cleanly into your project workflow and deliver to your schedule.